Gutter installation in Tulsa. Seamless, sized right, done once.
Tulsa gets about 40 inches of rain a year, and a lot of it falls in short, hard bursts. Gutters that are undersized, pitched wrong, or pulling away from rotted fascia don't manage that load. They redirect it straight into your foundation, your soffits, and your basement walls. We install seamless aluminum gutters sized for actual Oklahoma rainfall, not catalog defaults.
Q: How do I get seamless gutters installed in Tulsa?
Tulsa's housing stock runs the full spectrum. Midtown has bungalows and craftsman homes from the 1920s through 1950s, many of them still on their original wood fascia. South Tulsa has the 1990s and 2000s subdivisions where builders installed 4-inch aluminum gutters that were undersized from day one. The Pearl District and east Tulsa fall somewhere in between.
What they have in common is Oklahoma weather. Spring storms drop 2 and 3 inches of rain in under an hour. That kind of volume overwhelms undersized gutters and overwhelms gutters that are clogged or sagging. Water goes somewhere. Usually somewhere expensive.
We install seamless K-style aluminum gutters formed on-site to the exact length of each run. No couplers, no seams in the middle of a 40-foot section, no place for water to find a gap. Paired with proper fascia inspection and repair before any bracket goes in.
Why Tulsa homes need properly sized gutters.
The older homes in Brookside and Maple Ridge often have 4-inch round gutters that were standard when the houses were built. Those gutters couldn't manage the drainage load on a calm day, let alone during a July thunderstorm. Fascia boards behind them have been wet for decades. By the time most homeowners call us, we're replacing the gutter and the fascia at the same time.
South Tulsa's 1990s neighborhoods have a different problem. Builders installed 5-inch K-style gutters, which is right, but used the cheapest hangers on 24-inch spacing. After 25 Oklahoma winters, those hangers are pulling loose. The gutters sag between brackets. Water pools at the low spots, overflows behind the gutter, and soaks the fascia from the back side where you can't see it happening.
Newer construction east of 169 and south of 101st has mostly adequate gutter sizing, but the corners and miters are often caulked with standard silicone instead of gutter sealant. Silicone fails in two to three years in Oklahoma's heat cycle. The leaks start at the corners and run down the brick or Hardy board before anyone notices.
We address all of it the same way: measure the drainage area, select the right gutter size, form the run without seams, hang on proper spacing, and check the fascia condition before the first screw goes in. That is the job.
Four steps. No surprises.
Measure and assess
We measure every roof run, calculate the drainage area for each section, and inspect the fascia condition before quoting anything. If the fascia is rotted, we tell you before the gutters go up, not after.
Free / same weekForm on-site
Seamless aluminum gutters are formed to the exact length of each run from a coil in our truck. No seams in the field. No sections spliced together. One continuous piece from corner to downspout.
SeamlessHang correctly
Hidden hangers on 24-inch or tighter spacing, pitched toward downspouts at the proper grade. We pull a level on every run before we leave. Downspouts discharged away from the foundation.
Proper pitchTest and clean up
We run a hose test on every section before we pack up. Any adjustment gets made on-site, not on a callback. Job site cleaned and all old material hauled away same day.
Same-day testTimeline, cost, and warranty.
Most Tulsa gutter installations take one day from crew arrival to cleanup. Larger homes or those needing fascia replacement first may take two days. We will tell you at the estimate which applies to yours. No surprises on day of install.
Cost on a standard Tulsa home runs $800 to $2,400 depending on linear footage, gutter size, and whether fascia work is needed. We price by the linear foot with a written quote before anything starts. The price you see is the price you pay.
Every gutter installation comes with a written warranty covering both materials and workmanship. If a hanger pulls loose or a seam at a corner fails in year one, we come back and fix it. You have our number.
Your foundation is worth protecting.
ZIP codes and neighborhoods we cover:
One crew. No subcontractors.
Most gutter companies are two guys in a pickup with a coil machine and a list of addresses. They are in and out fast. What gets skipped is the fascia inspection, the pitch check, and the downspout discharge. You get gutters that look fine and leak behind the fascia for years before you notice.
AE Roofing is based in Tulsa. We do gutters as part of a full exterior scope, which means we are already checking fascia, soffit, and siding condition when we arrive. If something needs attention before the gutters go up, we tell you at the estimate. You decide what to fix.
Our crews are vetted professionals. The same crew that shows up for your estimate shows up for your install. We do not hand your job to a sub. We do not disappear after the check clears.
Questions from
Tulsa homeowners.
Not on the list? Call us. A human picks up.
Ask us directly →The next storm
isn't waiting.
Whether your shingles are curling, your gutters are sagging, or you just want a second opinion before your insurer's deadline runs out, book the inspection. We don't charge for it, and we don't push for it.
(918) 978-2660Direct line · 7am – 9pm · 7 days